Rotoverter Part 1 – Doug Konzen Rotoverter AC Motor
This particular 3450rpm marathon-brand 3ph 2hp AC motor shown in the video I eventually got to run on .18amps (180milliamps) at 120Vac with no load on shaft, using a 9uf run cap. The rotovertor is a discovery of Hector Torres and has been replicated and tested by hundreds of people since it was introduced publically around 8 years ago by Hector. This sort of motor has the ability to actually "run itself" if you spin a super effecient generator, and also pull out power not only from the generator, but also what the AC motor itself in rotovertor mode makes in additional power from its third "virtual" phase - this phase works more or less like a "rotary transformer" Study the rotovertor circuit and you will see that the third phase does not draw electricity, but in fact makes AC power itself that can be extracted. Look on my geocities site for the rotovertor circuit in "circuit diagrams" link - also look at the circuit there in that link that uses a 2nd trigger-transformer to pulse-out power from that 3rd virtual phase at the motor's sinewave peaks to charge 2nd battery stacks so there is "no reflection" to the input power to the motor itself. This can also be done using a strobe-light light sensor trigger circuit too. my site: www.geocities.com/koneheadx/ Also look at link #16 which shows a 5hp 1850rpm rotovertor AC motor spinning a Bill Muller design type of dynamo/generator. This generator should have its power-out pulsed out at the peaks of the sinewave that the coils ...








Free Energy is real and its here! The Oil companies are doing everything they can to stop these
information. If you want a Free energy machine , get the blueprints at LT-MAGNET-MOTORdotCOM , Join the
revolution!
Thanks!! That's just what I did...
it is wired to highest voltage rated circuit in the motor (460V one) then you run it on only 120V (usually)
You can use variac or transformers to recuce voltage input even more
26VAC is anout as low as you want to go - also amps input will go down too doing that tpo - you cn get them around 5watts input! but shaft power goes WAY down like that but it will still spin at 1800rpm or 3600rpm; if 2pole or 4 pole type motor
get a 7.5hp motor for best effeicncy
maybe spin a big flywheel with it
Nice video...
Hey dude, according to my understanding in this video, RV is a 3-phase motor that run at very low voltage, right?
Can I apply this to my big air compressor?
I mean, I'll take a step-down transformer, then connect it to my air compressor motor, then, I tune it to match the resonance...
Am I right? My air compressor electric bill is killing me!!
Thanks dude!!